After upgrading Connectrix NX-OS to 8.4(1) or 8.4(1a), the “no shutdown” command for the port-channel interfaces displays in the startup-config, but it is not shown on the same interface in the running-config.
Welcome to Dell technologies connect Cisco M DS break fix series interface. No shutdown command does not show in the running config after N XOs upgrade 8.41 and 8.41 A reference Dell Knowledge Base article number 77853 This video was created to explain why interface no shutdown command does not show in the running config after an in service software upgrade 8.41 and 8.41 A. This video presents the following after upgrade to 8.41 or 8.41 A no shutdown command for the port channel interfaces displays in the start up config but it is not shown on the same interface in the running. Config. This causes management applications to indicate there is a difference between the port channel interfaces in the running config and start up config even though the actual port channel interface status is correct. In this example, no shutdown is not listed in Lennington fig.
It just indicates that port channel is a no shutdown state which means it's not shut, meaning it's operational when to do this symptom. One show running config difference command shows a difference in number of lines between the running and start up config and points to the differences in start up config under the port channel configuration, symptom. Two outright comparison of the show running config versus the show start up. Config outputs shows the difference between them before you begin. Details of issue interface. No shutdown command does not show in the running config after an in service software upgrade to 8.41 work around in service software downgrade to a previous unaffected level. Previous to 8.41 no shutdown command will not be displayed on the port channel interfaces in either running config or start up config fix upgrade to NX OS 8.4 0.2 or above.
Check the current N XOs version running on the switch, check the difference between running config and start up. Config you can notice that there is a difference in number of lines between the running and start up. Config it points to the differences in start up config under the port channel configuration. Now verify the status of interfaces listed under the differences these interfaces are up and operational. Now let us say the running config to start up config verify the running config difference.
Again, you can still see the same differences. Check the interface port channel three configuration in running config check the same port channel three configuration in start up. Config this comparison indicates that no shutdown is not listed in running. Config this causes management applications to indicate there is a difference between the port channel interfaces in the running config and start up config even though the actual port channel interface status is correct. Important notes, this is a cosmetic issue.
It has no impact on function previous to NX OS 8.41 no shut down on a port channel interface does not show in the running or start up config. However, shutdown does show in both running and start up. Config refer to the following for more information Dell Knowledge Base article number 77853
Thank you for watching.
